ITW GSE 7400 - Page 79

Operation Manual – ITW GSE 7400 Battery Powered GPU
90 kVA
Operator’s Instructions
Document No. 575.410DB Page 79 of 195
Update Software / Save Logs / Load Config File (Continued)
10:30:00 USB MENU 24/09/2019
Update Display Software
Update Control Card Software
Save Logs
Load Config File
 Back  Select
Highlight the by using the navigation
keys.
Press to select USB Menusubmenu.
Use the /to highlight the function
Load Config File.
Before pressing  to select Update Control Card
Software, please remember to insert a USB
stick into the USB port on the control card
(located on the interface board).
Press to select function.
The new unit configuration will now be uploaded
from the USB stick and Configuration complete
will be displayed when the upload is complete.
Press to reset control card.
Note
The USB stick can be inserted while the unit is
connected to the power.
10:30:00 USB MENU 24/09/2019
Reading Flash Drive. Please Wait
Press  To Reset
10:30:00 USB MENU 24/09/2019
Configuration complete.
Press  To Reset Control Card
USB connection
Control card