SAFETY
Model 7600/7800 Operation Manual 9
Guidance and manufacturer’s declaration – Electromagnetic immunity
The Model 7600/7800 monitor is intended for use in the electromagnetic environment specified
below. The customer or the user of the Model 7600/7800 should ensure that it is used in such an
Electromagnetic environment –
guidance
discharge (ESD)
IEC 61000-4-2
±8kV air
±12kV air
Floors should be wood, concrete,
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should be at
Transient/burst
IEC 61000-4-4
supply lines
±1 kV for
supply lines
±1.5 kV for
Mains power quality should be
that of a typical commercial or
hospital environment.
IEC 61000-4-5
mode
±2 kV common
differential mode
±3 kV common
Mains power quality should be
that of a typical commercial or
hospital environment.
interruptions, and
voltage variations
on power supply
input lines
IEC61000-4-11
T
(>95 % dip in U
T
)
for 0.5 cycle
40 % U
T
(60 % dip in U
T
) for
5 cycles
70 % U
T
(30 % dip in U
T
) for
25 cycles
<5 % U
T
(>95 % dip in U
T
)
T
(>95 % dip in U
T
)
for 0.5 cycle
40 % U
T
(60 % dip in U
T
)
for 5 cycles
70 % U
T
(30 % dip in U
T
)
for 25 cycles
<5 % U
T
(>95 % dip in U
T
)
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of the Model 7600/7800 requires
continued operation during power
mains interruptions, it is
recommended that the Model
7600/7800 be powered from an
uninterruptible power supply.
(50/60 Hz)
magnetic field
IEC 61000-4-8
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital