jablotron JA-14KR - Page 19

JABLOTRON ALARMS a.s.
Pod Skalkou 4567/33 46601 Jablonec n. Nisou
Czech Republic www.jablotron.com
||
|
JA-14K(R) Security System Control Panel 19 / 72 MNX22101
System parameter overview when the „DEFAULT“ system profile is set:
Device
Parameter
Option
Blocking
(limitation)
Control panel
Siren when partialy set (IW)
NO
NO
Control panel
Sirens enabled
YES
NO
Control panel
Administrator – restricted Service/ARC rights
NO
NO
Control panel
Service and ARC controls the system
YES
NO
Control panel
Duress access control
YES
NO
Control panel
Alarm confirmation within one section
NO
NO
Control panel
Siren (IW output) when a tamper is triggered
NO
NO
Control panel
Reset enabled
YES
NO
Control panel
Report unset section
NO
NO
Control panel
Unsuccessful setting
NO
NO
Control panel
Alarm memory indication
YES
NO
Control panel
Alarm length
240 5…1200 s
Control panel
Entrance delay
30 5…120 s
Control panel
Exit delay
30 5..120 s
Control panel
Entrance delay by garage door
60 5…360 s
Control panel
Exit delay by garage door
60 5…360 s
Control panel
Period of waiting for alarm confirmation
10 1…60 min
Control panel
Waits for confirmation of fire of another detector
10 1…60 min
Control panel
Delayed report to ARC
NO
NO
Control panel
Ways of setting
Set with warning
NO
Control panel
Authorization type
Standard
NO
Control panel
Supervision of wireless devices
YES NO
Radio module
RF jamming detection
Disabled
NO
Keypad
Optical indication setting
1.Permanently (BUS)
or 2.Section status
change
NO
Keypad
Alarm acoustic indication
YES
NO
Keypad
Entrance delay acoustic indication
YES
NO
Keypad
Exit delay acoustic indication
YES
NO
Remote controls
Control function limitation
NO
NO
Control panel
calendar
Control function limitation
NO NO
By setting the “Default” system profile, all the mentioned parameters are pre-set back to factory settings
and all inaccessible parameters are accessed for changes to be performed. The alarm system then doesn´t
comply with the requirements of security grade 2 and also violates the requirements given by the insurance
company or local regulations. In the case of a harmful event, the insurance company doesn´t have to pay for the
damage because of broken regulations and an incorrectly programmed system caused by the installation
company.