JABLOTRON ALARMS a.s.
Pod Skalkou 4567/33 46601 Jablonec n. Nisou
Czech Republic www.jablotron.com
||
|
JA-14K(R) Security System Control Panel 55 / 72 MNX22101
to the manufacturer’s server to provide it with the registration code and phone number of the SIM card
inserted in the control panel communicator. There must be functional data communication in the control
panel (LAN or GSM/GPRS).
Persistent (LAN) – the control panel maintains a permanent data communication with the server,
it allows remote connection with the N-Link software is possible.
JABLOTRON communication – the device communicates with the manufacturer’s server
(MyJABLOTRON application) and continuously sends information about the device status to it. Thus,
if the N-Link sends a request for remote connection, the server is immediately ready to establish
connection. In addition, this communication allows the user to use server services. Applications allowing
the user to operate the system can be installed in mobile devices with the Android or iOS systems.
Contact your distributor for information about the possibilities of using each communication type in your country
Settings – The button serves for registering the system to CLOUD services for web and smart application use.
When you fill in the form and send the data for confirmation it creates a registration request. Confirmation of the
filled in form will be done in a few moments.
10.10.1 JA-190Y Settings
The button is used to set the parameters and behaviour of the JA-190Y supplementary GSM communicator
GSM communicator – possibility to switch off the communicator.
GSM signal – information about the signal strength in percent (it is measured once every minute). For proper
function the signal should be at least 50%. If you encounter problems with GSM signal quality, you are
recommended to test a SIM card of another operator. You are not recommended to use a directional or gain
GSM antenna for the communicator (it only reduces connection of the module to 1 network cell = unstable
communication). You can also get information about the signal quality using the SMS command STATUS
(see 9.7 SMS commands).
PIN – We recommend using a SIM card with the PIN code disabled.
APN – GPRS data communication settings. Data communication provides access to services such as remote
access of a service technician and user as well, communication with the ARC etc. Besides the APN settings the
used SIM card must support data transmission.
APN User – name (do not enter one unless the network uses it).
APN Password – password (do not enter one unless the network uses it).
Diacritic allowed – if international character accents (ICC) are allowed, reports can be sent from the system
via more than one SMS text message. ICC must be enabled if you use e.g. Russian alphabet in your texts etc.
Remote control via telephone – setting the possibility to control the system remotely using the voice menu.
If Users are selected, the menu can only be accessed from the phones of defined users (in the Communication
tab you can even allow users to enter the voice menu without entering their user code – the Voice menu without
code option). If “Anybody” is selected, the voice menu can be accessed from any phone. However,
on accessing the menu the user is always requested to enter the user’s code.
Remote control by sending SMS – setting the possibility to control the system remotely with the use of SMS
commands. If Users are selected, the system only accepts SMS commands from the phones of defined users
(in the Communication tab you can even allow users to use SMS commands without entering their user code –
the Voice menu without code option). If “Anybody” is set, an SMS command can be set from any phone;
however, it is conditional on entering the access code.
To Next Page