33
07610-003-62-15-Q
SERVICE PROCEDURES
SERVICE
2. Using the 5/16” nutdriver, loosen the clamps on the suction hose.
3. Using the same nutdriver, loosen the disharge hose where it connects to the
tub weldement.
4. Pull the discharge hose out and away from the tub.
5. Remove the motor assembly mounting nuts using the 7/16” combination
wrench.
6. With the nuts removed, grasp the motor assembly and lift up on it to clear the
mounting studs.
WASH MOTOR
REPLACEMENT
To Next Page
Loading...
