3-22 4247530-Rev A
ENGINE
3
Figure 3-40
4. Remove nut (13), lock washer (8), washer (14), and
muffler clamp (7).
5. Disengage muffler (1) from exhaust pipe (9).
6. Remove screw (12), lock washer (11), and muffler
support (10).
Installation Note
Install muffler by reversing the order of removal.
Throttle Cable (Gasoline)
Removal and Installation
See Figure 3-41.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely.
Figure 3-41
3. Remove two nuts (3), lock washers (4), and screws
(1), and remove throttle cable (2) from bracket (5).
4. Disengage throttle cable at the engine.
Installation Notes
• Install throttle cable by reversing the order of
removal.
• Adjust throttle cable as needed. (See “Throttle Cable
Adjustment” on page 3-8.)
TN3478
12
7
11
14
13
10
1
9
8
TN3558
4
3
1
2
5
To Next Page
Loading...
