ENGINE
4247530-Rev A 3-25
3
Installation Notes
• Inspect engine isolation mounts and replace if
necessary. Tighten engine isolation mounts to 19.6–
21.7 lb-ft (27–29 N·m).
• Install the engine by reversing the order of removal.
• If necessary, remove components from the engine
and install the components on the new engine.
• Use new cable ties to secure wire connectors and
wire harnesses.
• Apply dielectric grease (Jacobsen PN 365422) to any
wire connectors disconnected.
• Replace the engine oil filter and fill engine with oil.
Engine Service (Gasoline)
A separate engine manual, prepared by the engine
manufacturer, is supplied with this machine. Refer to the
engine manufacturer’s manual for all engine-related
service.
Proper attention to the engine manufacturer’s manual
directions will ensure maximum service life of the engine.
To Next Page
Loading...
