Jacobsen R-311T Maintenance Manual

119
> Change from previous revision
R-311T
Item Part No. Qty. Description Serial Numbers/Notes
1
64173-02 6 Pin, Snap RIng
2 3000439 2 Clevis Pin, 1/2 x 3-3/4”
3 3000487 1 Clevis Pin, 5/8 x 3”
4 346913 2 Spacer
5 460050 2 Cotter Pin, 3/16 x 1-1/4”
6 3006300 1 Clevis Pin, 5/8 x 3-5/16”
7 362464 12 Wheel Bolt, 7/16-20
8 340433 4 Ring Shaft
9 346294 12 Nut, 7/16-20 Wheel Lug
10 400192 2 Screw, 5/16-18 x 1-1/2” Hex Head
11 366520 2 Retainer Pin
12 446136 2 Lockwasher, 5/16 Heavy
13 443106 2 Nut, 5/16-18 Hex
14 366484 2 Shaft, Pivot
15 162716 2 Shackle
16 132600 2 Caster Support
17 163995 4 Pin
18 REF 1 Front Deck Assembly See 43.1
19 REF 1 Left Wing Deck Assembly See 44.1
20 REF 1 Right Wing Deck Assembly See 44.1
21 367601 4 Washer, Thrust
22 2246003 1 Baffle
23 441602 6 Carriage Bolt, 5/16-18 x 3/4”
24 452006 6 Flat Washer, 5/16
25 445802 6 Nut, 5/16-18 Flex Lock

Jacobsen R-311T Specifications

General

Cutting Width	21 in
Weight	Not available
Fuel Type	Gasoline
Engine Type	Kohler CH740
Drive Type	Hydrostatic
Height of Cut	1.5 to 5 inches
Engine	Kohler CH740
Transmission	Hydrostatic
Cutting Height Range	1.5 to 5 inches