V03
JCAII 10
2. Use numeric key to input the low limit value. Eg. 0.1kg.
3. Press to save and return.
Enable/disable the Auto-tare function
1. Under normal weighing mode, press or . appears in the Total Count window.
(If not press )
2.If you want to enable auto-tare function, press
If you want to disable auto-tare function, press
8-3 Counting method
8-3-1Key in a known unit value
1. Use numeric key to input the unit weight value(eg.1.2g), then press key
2. Put the article on the pan, and the scale starts counting
Note: Symbol “ ” points at “UW” when entered unit weight is lower than 4/5 of scale division. Unit
weight is too small for ensuring accurate quantity calculations.
8-3-2 Sample counting
Note: Do tare or zero-point before doing the following steps
1. Put samples onto the weighing pan and input the quantity with the numeric key.
(eg. 0.300kg, 20pcs)
2. Press key . The unit weight is calculated
3. Remove the samples and put on the articles, the scale begins to count
Note: Symbol appears pointing at “ ” in the Unit Weight window when sample quantity is
less than 10 pieces.
To Next Page
Loading...
Need help?
General
