12) SET11 printing format setting: prt01~prt03
13) SET12 filtering setting: 1, 2, 3, 4
1：Suitable in very stable environment with the quickest weighing
2
：
Suitable in the common environment
3
：
Suitable in a bit shaking environment
4：Suitable in the very shaking environment with the slowest weighing
14) SET13 zeroing or taring setting: stable, auto, always
stable ：Taring or zeroing works when stable only
always：Taring or zeroing works no matter it is stable or not
auto： Press key TARE or ZERO when unstable, but it works when stable.
15) SET14 time setting (optional): on, off
RTC setting: press key G N/SET to enter RTC setting and set to on. Press key
G N/SET again to enter the RTC window. Press key G N/SET to enter the figure
changing and key
/MR or TARE/
to shift the figures. Press key M-/HI or
PRINT/LO to modify the value (or via numeric keys). Press key M+/SAVE to save and
shift the windows.
16) SET15 weight memory parameter: on, off
On: display the last weight when powering on again
Off: do not display the last weight when powering on again
17) SET16 the kinds of checking: Qty.ck, Wt.ck
Qty.ck: start amount checking
Wt.ck: start weighing checking
18) SET17 parameter initialization
press key G N/SET then key M+/SAVE to start initialization. It is finished when
displaying OK.
6. Single and Multi-point Calibration
Note: Before calibration, please set the capacity first. The unit used in calibration is the one
that has been set before. During the calibration procedure, LONG press ZERO/ESC to
return to normal weighing mode without saving.
Here we take 3kg/10g as an example
1. Press and hold TARE/ while powering on.
Do not release it till the window displays “CAL”
2. With no load on the weighing pan,
To Next Page
Loading...
Need help?
General
