JADEVER JCE/JWE Service Manual - V05
As per the right of proprietary intellectual property, may not be reproduced in any form without written permission.
18
Ø Printing mode
Printing mode is used to set the method of printing when connected with a printer.
1. Press MC/SET until display shows Prt.Pr. Prt.Pr
2. Press M+/MR to set the printing method, as following:
Pr:
Data will be sent to printer only when key is pressed.
Co:
Data will be sent to printer continuously.
St:
Data will be sent to printer when stable indicated.
Ø External printer/device
External printer/device function is used to set the type of external connected device.
1. Press MC/SET until display shows Peri. Wait for few seconds, display will show
PC
2. Press M+/MR to set the external printer/device, as following:
PC:
Personal computer
SH:
SH-24 printer
TDP:
TDP-643/BP-343D printer
EZ:
EZ-2 printer
Ø Weight-checking memorizing
Weight-checking memorizing function is to determine whether or not to memorize the check
weight.
1. Press MC/SET until display shows M OFF. M OFF
2. Press M+/MR to set whether or not to enable weight-checking memorizing. To select
either ON or OFF.
Ø Weight-checking beep mode
This is to set, in weight-checking mode, the condition at which buzzer is actuated to beep.
1. Press MC/SET until display shows bEEP.Un. bEEP.Un
2. Press M+/MR to set the condition, as following:
Un:
Buzzer will be actuated when measured weight is above the set high limit.
ln:
Buzzer will be actuated when measured weight is in-between the upper and lower
set limits (including the upper and lower limits).
no:
Buzzer will be actuated when measured weight is outside the upper and lower
limits.
Lo:
Buzzer will be actuated when measured weight is below the set low limit.
To Next Page
