Jandy Pro Series Owner's Manual

Nicheless Underwater LED Lights | Owner’s Manual
Nicheless Underwater LED Lights | Owner’s Manual
ENGLISH
Page 11
CAUTION
To prevent risk of fire which could result in property damage,
and to ensure optimum performance, do not exceed the load
factor specified in the instructions provided by the transformer
manufacturer
.
Class 2 Magnetic Transformer
Output: 12-14 VAC
Ground Bar
White - Neutral
White - Neutral Green - Ground
Black - Hot (Line)
Black - Hot (Line)
Time clock, Automation relay,
or switch
Figure 5. Wiring LED Lights to a 12 Volt Magnetic Transformer
NOTE A magnetic low-voltage dimmer switch or dimming relay may be
used when Jandy Pro Series Nicheless WHITE ONLY lights are
installed. Jandy Pro Series color lights are NOT DIMMABLE and
are NOT COMPATIBLE with dimmer switches or dimmer relays.
Section 5. Jandy
®
Pro Series Nicheless
Underwater LED Light Operating Instructions
5.1 Light Synchronization
NOTE This section only applies to the color (RGBW) lights. All xtures
must be tied into the same transformer, circuit or switch for
synchronization to occur.
1. Turn the light ON. If the light has been off for 7 seconds or longer, the
light will turn on with the last color selected.
2. To synchronize multiple lights to the same color mode, you will need to
reset to the beginning of the color mode sequence. With the lights ON,
turn them OFF for five (5) seconds, then turn ON again. All of the lights
will reset to the Alpine White color mode. If all of the lights are not in
the Alpine White color mode, they have not been synchronized, repeat
step 2.

Jandy Pro Series Specifications

General

Brand	Jandy
Model	Pro Series
Category	Controller
Language	English