Page 8
ENGLISH
Nicheless Underwater LED Lights | Owner’s Manual
Nicheless Underwater LED Lights | Owner’s Manual
NOTE: Service
Loop not applicable
for Junction Box
Installations.
Vertical Installation for
Benches, Swimouts and
Fountains
12VAC Magnetic Pool Transformer,
see table 3.2 for more details
The light face must be completely
snug with the light fitting without
any protrusion from the light fixture.
Conduit to 12VAC Magnetic Transformer
12VAC Magnetic Transformer
Except when the luminaire is
installed in an area of the swimming
pool that is not used for swimming
and the lens is adequately guarded
to keep any person from contacting
it, vertical installations should not
be done unless they are provided
with guards acceptable to the local
AHJ (Authority Having Jurisdiction)
to protect them from contact with
bathers/swimmers.
Figure 3. Standard installation with 1.5” pool wall fitting
Section 4. Wiring Options for Controlling
Jandy
®
Pro Series Nicheless LED Lights
NOTE: Always consider the cable length when calculating the input
voltage at the transformer. The maximum run of service
between transformer and lights should not exceed 150ft. in
length, inclusive of the use of a J Box or not.
To the extent allowed by local installation codes in effect in the
installation jurisdiction and capacity of the electrical equipment,
multiple Jandy Pro Series lights may be controlled with a single
switch and a 12VAC magnetic transformer so their colors may be
synchronized.
IMPORTANT NOTE: All xtures must be tied into the same
transformer, circuit or switch for synchronization to occur. The use of
Solid Core over Stranded wire and terminating Bus Bars is strongly
recommended.
4.1 Wiring to an AquaLink
®
Controller
The Jandy Pro Series Nicheless LED Lights can be controlled by an
AquaLink controller. Connect the transformer powering the lights to
one of the auxiliary relays in the AquaLink.
Refer to Figure 4 to connect the Jandy Pro Series Nicheless LED
Lights to the Power Center.
To Next Page
Loading...
Need help?
General
