Page 6
ENGLISH
Nicheless Underwater LED Lights | Owner’s Manual
Nicheless Underwater LED Lights | Owner’s Manual
3. A standard 1.5” plastic wall / return tting (not included) must be
installed so that the top edge of the underwater light’s lens is at least 4
inches (10.2 cm) below the surface of the water in the pool.
See Figure 1.
NOTE: For optimal lighting results it is recommended to place lights 12-18”
below the water line.
NOTE: To be certain that the pool’s electrical system meets all applicable
requirements, the electrician should also consult the local building
department.
12 VAC Class 2 Magnetic
Transformer or
Junction Box
48” min.
Check AHJ for other J-box requirements
8” minimum to maximum water level
1.5” pipe. Length requirement varies
by model. (See Table 1)
Rigid 1” electrical conduit. Sweep
elbows only, no 90º elbows.
NOTE: Verticle installations such as bench and walk-out locations will use ALL of the same clearance requirements.
The light face must be completely snug with the light fitting without any protrusion from the light fixture.
4” minimum to top of lens
Maximum possible water line.
(top of copping)
Figure 1. Jandy
®
Pro Series LED Light Installation with Standard 1.5”
Plastic Fitting
Use the chart below to determine the appropriate pipe length for your
installation.
WATTS MINIMUM LENGTH FOR 1.5” PIPE
6W 7”
12W 10”
24W 10”
All products listed above come in a variety of cord lengths. Cord lengths
come in 50, 100 & 150 feet lengths.
Table 1. Jandy
®
Pro Series LED Light Minimum 1.5” pipe length
To Next Page
Loading...
Need help?
General
