Janome 6260QC - Square Buttonhole (continued); Double Layer Buttonhole

Replacement and Adjustment of Upper Shaft Sensor
During zigzag sewing, lateral movement of the needle should take place 7.4 to 9.8 mm above the
needle plate.
Adjustment procedure:
1. Remove the top cover (see page 15).
2. Select the zigzag stitch “ “ and turn the handwheel to check the lateral movement of the needle.
If the needle starts lateral movement higher than 9.8 mm: Loosen the setscrew (C) and turn the
upper shaft shielding plate in the direction of (A).
If the needle starts lateral movement lower than 7.4 mm: Loosen the setscrew (C) and turn the
upper shaft shielding plate in the direction of (B).
3. Attach the top cover.
To replace the upper shaft sensor:
1. Remove the front cover (see page 8).
2. Remove the board supporter (see page 23) and unplug the upper shaft sensor connector.
3. Remove the 2 setscrews (D) and remove the sensor mounting.
4. Remove the 2 setscrews (E) and remove the upper shaft sensor.
To attach:
5. Follow the above procedure in reverse.
7.4 to 9.8 mm
Setscrew (C)
(B)
(A)
Setscrew (E)
Upper shaft sensor
Sensor mounting
Setscrew (D)
27