Janome 6260QC - Zipper Application; To Attach the Zipper Foot; Fabric Preparation

Adjusting Bobbin Winder Switch
The LED display shows “ ” when the bobbin winder spindle is set to the left and “ “ when
the bobbin winder spindle is set to the right.
Adjustment procedure:
1. Remove the top cover (see page 8).
2. Set the bobbin winder spindle in the sewing position and loosen the setscrew.
Adjust the clearance between the bobbin winder arm and the switch mounting to 0.7-1.3 mm.
3. Tighten the setscrew.
4. Attach the top cover.
Setscrew
Switch mounting
Bobbin winder arm
0.7 to 1.1 mm
Sewing position
Bobbin winding position
32