Janome 6260QC - Threading the Machine; Threading the Needle Thread

Adjusting screw (C)
(E)
(D)
Feed balancing dial
Insert the screw driver through the poening
Mechanical adjustment
Stretch Stitch Feed Balance
If the stretch stitch patterns are deformed when sewing the patterns with the feed balancing dial is set at
the standard position “ “, correct it as follows:
Adjustment procedure:
1. Select the straight stretch stitch “ “.
2. Set the feed balancing dial at the standard position “ “.
3. Place a piece of paper on the machine and lower the presser foot. Rotate the handwheel several turns
and check the needle marks in the paper.
4. Insert the screwdriver through the opening of the base to access the adjusting screw (C).
If the forward feed is longer (A>B): Turn the adjusting screw in the direction of (D).
If the backward feed is longer (B>A): Turn the adjusting screw in the direction of (E).
13