Janome Continental M17 - Page 143

 cm 
 cm 
qq
w
e
r
 cm 
141
Left of teeth
Raise the foot and replace it with CONCEAL® zipper
foot Z.
Remove the basting stitches.
Open the zipper and insert the pull tab between fabric
and zipper tape to allow the slider to reach the stopper.
q
Pull tab
Right side of tape
Turn and fold the bodice to the left.
Seam along the edge of the right zipper tape and reverse
the stitches  cm  eore the ipper ottom
Left side of tape
Raise the foot and close the zipper.
Replace the foot with zipper foot E.
Turn and fold the bodice to the right. Seam along the
edge of the left zipper tape and reverse the stitches 2 cm
 eore the ipper ottom
Raise the zipper teeth on the left and lower the foot so
the right groove of the foot catches the zipper teeth.
Stitch through the zipper tape and fabric up to the end of
the opening. Reverse the stitches to secure the seam.
w
Zipper teeth
e
Right groove
ide up the stopper to  cm  eo the end o the
opening and fasten the stopper with pliers.
r
Stopper
* “CONCEAL” is a registered trademark of YKK
Corporation.