Janome HD9 - Built-In Needle Threader

28
z
Lower the presser foot. Press the Up/Down needle
button twice to raise the needle to its highest
position. Turn the power switch off.
Push down the needle threader knob
q
as far as it
will go.
Built-in Needle Threader
z
r
w
e
q
x
c
v
b
x
Turn the knob
q
in the direction of the arrow to
insert the hook into the needle eye.
The hook
r
comes out through the needle eye
as illustrated.
c
Holding the thread with both hands, draw the
thread along the thread path
w
.
Then hook the thread around the guide
e
.
v
Draw the thread under the hook
r
.
Hold the end of thread with your hand while pulling
up the thread lightly in the direction of arrow.
b
Turn the knob in the direction of the arrow as
shown, drawing the thread loop
t
through the
needle.
Release the threader knob slowly. Then pull the
thread loop
t
to the right.
t
The needle threader may not work
well with these combinations.
#9 #20, #30, #50, #60
Needle
#11 #20, #30
#14 #16, #20, #30
Thread