Janome HD9 - HOW to SEW Test Stitching

36
Before you start sewing your garment, try test
stitching with the same thread and fabric as your
garment.
z
Turn the stitch length adjustment dial
q
to
adjust the stitch length.
Slide the needle and bobbin threads to the back
under the presser foot. Use the same fabric for
actual sewing.
x
Turn the handwheel
w
toward you to lower the
needle into the fabric.
c
Set the speed control slider to
(slow) until you
get used to the sewing speed.
Lower the presser foot lifter
e
.
Press the foot control
r
to start sewing.
z
x
c
v
b
NOTE:
Raise the thread take-up lever to its highest
position, otherwise the needle thread may slip out
from the needle eye.
Test Stitching
w
e
r
t
y
u
q
HOW TO SEW
v
Check the sewing result and adjust the needle
thread tension
t
as necessary.
b
Press the auto thread cutter button
y
to trim the
threads.
You can continue sewing without pulling the
bobbin thread up to the needle plate after
trimming the threads.
* Use the thread cutter
u
on the face cover if the
thread is thicker than #30.
Palanca tira hilos
Bras de relevage
du l
Thread take-up
lever
NOTE:
The machine will not run if the presser foot is in
up position.