1. ENVIRONMENT
■ Place the machine on a suitable flat surface that can support its weight.
Be sure to leave a space greater than 30cm between the back of the control box equipped with a
cooling fan and the wall. Do not cover the cooling fan vent on the top of a stand-alone or head
type press. An insufficient or unstable area can cause the machine to fall, overturn, breakdown,
or overheat.
■ If you use an installation mount, it should be able to support the machine’s
weight.
The installation mount should be steel. For the stand-alone type, it should be able to support the
machine’s weight. For the head and unit types, it should be able to support the machine’s
weight and pressing capacity.
■ Place the machine in a well-ventilated area for the health and safety of the
operator.
■ Do not use the machine near inflammable or corrosive gas.
If leaked gas accumulates around the machine, it can cause fire or explosion. IP Protection
Rating is “IP40.”
■ Use the machine in an environment between 0 to 40 degrees centigrade
with humidity of 20 to 95 percent without condensation.
Use outside these conditions may result in malfunction.
IP Protection Rating is “IP40.”
■ Avoid using any equipment emitting electric noise nearby.
Electric noise can cause the machine to break down.
■ Use the machine in an environment where it is not exposed to direct sunlight.
Direct sunlight may cause malfunction or defect.
■ Use the machine in an environment that is not dusty or damp.
Setup Electro Press JP Series 4 1
To Next Page
Loading...
