Setup Electro Press JP Series 432
3-6 Safeguard Installation
<How to install a safeguard>
Remove the switch box and install the area sensor and safeguard.
Remove the screws.
Remove the switch box fixing plate.
Remove the screws.
Remove the rear cover.
1
2
5
4
Pull the switch box out and release the cord
from the cord clamp.
6
Loosen the cord
clamp screw.
After installing the area sensor, check that the cord is not
loose and fasten the cord clamp screw.
3
7
Cord Clamp
To Next Page
Loading...
