4. HOW TO BACK UP UNIQUE NUMBER
AND INSTALL SETTING DATA
Each machine has a unique number and its own initial setting data.
Be sure to back up this data since it may be necessary when replacing internal board due to
malfunction.
Be sure to back up the unique number and initial setting data of the
machine.
It may be necessary when replacing internal board.
<Preparation>
Check that the machine is properly connected to your PC, turn the machine and the PC ON and
copy ”JPPSDBKE.EXE” from the Operation Manual CD-ROM to the local disk.
1. Start up “JPPSDBKE.EXE” from the local disk. The dialog
box to the right will appear.
2. Select the COM port used to connect the PC to the
machine and click [OK.]
3. Click [Download] to start downloading the unique number
and initial setting data of the machine.
If you want to select another COM port, select [COM
Status] from the pull-down menu [COM.]
4. After downloading is complete, save it as a new file. (It is
saved with the extension “.JEB”.) Click [Close] to exit
“JPPSDBKE.EXE.”
z Do not execute [Send C&T Data] from the pull-down menu [COM Status.]
Setup Electro Press JP Series 4 35
To Next Page
Loading...
