2. Turn ON the machine again, copy the “JPJSYLDE” software included in Operation Manual
CD-ROM to the local disk on the PC and start it up.
3. Select the communication port status of your PC which is connected to the machine and then
click [OK.]
4. Select [Open] on the dialog box and specify the press system software to be downloaded.
Then click the Send button.
5. After data sending is complete, turn the machine OFF, turn the special mode switch OFF
and then reattach the cover.
z If you are using “JP Designer”, the same operation can also be executed by selecting [Send
Press System Software] from the [Press] pull-down menu.
Setup Electro Press JP Series 4 37
To Next Page
Loading...
