Jasic TIG 200 AC/DC Digital Series - TIG Parameter Selecting Zone; MMA Parameter Selection Area; Foot Control Selecting Zone

11
5—TIG parameter selecting zone
Hz
%
% Hz
2
1
3
4
5
6
7
8
9101112
!
6-MMA Parameter selection area
$
7—Foot control selecting zone
Select the foot control to control the welding current by pressing the foot control key until the LED is on. The welding current
should be 30A at least (to avoid arc breaking due to overly low current) and should not be higher than the pre-set current. The
foot control is effective only in TIG mode.
1-Pre-flow time
7-Pilot arc current
2-Initial current
8-Post-flow time
3-Upslope time
9-Pulse frequency
4-Base current
10-Pulse duration ratio
5-Peak current
11-AC frequency
6-Downslope-time
12-Cathode current
1-Arc ignition current
2-Arc ignition time
3-Welding current
4-Arc force current
5-MMA parameter selecting key