Jasic TIG 315P Multi Wave - Burns and Radiation Protection; Fire and Explosion Prevention

A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1
form highly toxic and irritang gases.
Do not weld on coated metals unless the coang is
removed from the weld area, the area is well
venlated and while wearing an air-supplied
respirator. The coangs on many metals can give
o toxic fumes if welded.
Prevenon against burns and radiaon
Arc rays from the welding process produce intense,
visible and invisible (ultraviolet and infrared) rays
that can burn eyes and skin.
Wear an approved welding helmet ed with a
proper shade of lter lens to protect your face and
eyes when welding or watching.
Wear approved safety glasses with side shields
under your helmet.
Protecon against noise
Some welding and cung operaons may produce
noise.
Wear safety ear protecon to protect your hearing.
Protecon from moving parts
When the machine is in operaon keep away from
moving parts such as motors and fans. Moving
parts, such as the fan, may cut ngers and hands
and snag garments.
Protecons and coverings may be removed for
maintenance only by qualied personnel, aer rst
disconnecng the power supply cable.
Replace the coverings and protecons and close all
doors when the intervenon is nished and before
starng the equipment.
Take care to avoid geng ngers trapped when
loading and feeding wire during set up and
operaon.
When feeding wire be careful to avoid poinng it at
other people or towards your body.
Always ensure machine covers and protecve
devices are in operaon.
Precauons against re and explosion
Check and be sure the area is safe and clear of
inammable material before carrying out any
welding.
Accidental contact of electrode to metal objects
can cause arcs, explosion, overheang or re.
Avoid causing res due to sparks and hot waste or
molten metal.
Ensure that appropriate re safety devices are
available near the cung/welding area.
Do not cut/weld fuel and lubricant containers, even
if empty. These must be carefully cleaned before
they can be cut/welded.
Always allow the cut/welded material to cool
before touching it or placing it in contact with
combusble or ammable material.
Do not work in atmospheres with high
concentraons of combusble fumes, ammable
gases and dust.
Always check the work area half an hour aer
cung to make sure that no res have begun.
Risks due to magnec elds
The magnec elds created by high currents may
aect the operaon of pacemakers or
electronically controlled medical equipment.