Jasic TIG 315P Multi Wave - Product Overview

A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1
Wearers of vital electronic equipment should
consult their physician before beginning any arc
welding, cung, gouging or spot welding
operaons.
Do not go near welding equipment with any
sensive electronic equipment as the magnec
elds may cause damage.
RF Declaraon
Equipment that complies with direcve 2004/108/
EC concerning electromagnec compability (EMC)
and the technical requirements of EN60974-10 is
designed for use in industrial buildings and not for
domesc use where electricity is provided via the
low voltage public distribuon system. Dicules
may arise in assuring class A electromagnec
compability for systems installed in domesc
locaons due to conducted and radiated emissions.
In the case of electromagnec problems, it is the
responsibility of the user to resolve the situaon. It
may be necessary to shield the equipment and t
suitable lters on the mains supply.
LF Declaraon
Consult the data plate on the equipment for the
power supply requirements.
Due to the elevated absorbance of the primary
current from the power supply network, high power
systems aect the quality of power provided by the
network. Consequently, connecon restricons or
maximum impedance requirements permied by
the network at the public network connecon point
must be applied to these systems.
In this case the installer or the user is responsible
for ensuring the equipment can be connected,
consulng the electricity provider if necessary.
Materials and their disposal
The equipment is manufactured with materials,
which do not contain any toxic or poisonous
materials dangerous to the operator.
When the equipment is scrapped, it should be
dismantled separang components according to the
type of materials.
Do not dispose of the equipment with normal
waste. The European Direcve 2002/96/EC on
Waste Electrical and Electronic Equipment states
the electrical equipment that has reached its end of
life must be collected separately and returned to an
environmentally compable recycling facility.
Handling of compressed gas cylinders and
regulators
All cylinders and pressure regulators used in
welding operaons should be handled with care.
Never allow the electrode, electrode holder or any
other electrically “hot” parts to touch a cylinder.
Keep your head and face away from the cylinder
valve outlet when opening the cylinder valve.
Always secure the cylinder safely.
Never deface or alter any cylinder
3 PRODUCT OVERVIEW
This is a digital AC/DC inverter welder with a wide
range of funcons, high performance and advanced
technology. This mul-funcon welder with AC TIG
welding (square wave, triangular wave and sine
wave), AC pulsed TIG welding, DC TIG welding, DC