39
15 Amps. To adjust the stop switch slacken the screw by removing the bakelite
body of the switch to the right or to the left as required. Always check the stop
switch after adjusting the rear brake.
Maintenance of the mag-dynamo : Check the mag-dynamo after first 200 km.
(120 miles) and if necessary adjust the contact breaker point gap and ignition
advance. See para "Ignition timing",
Fig. 22. Removing the fuse
Setting the Ignition Timing:
a) Remove the sparking plug from cylinder and insert in the sparking plug hole
or screw in the gauge (indicator with thread M 14 x1.25, a special feeler gauge or
a straight piece of wire).
b) Find the T.D.C. of the cylinder by rotating the crankshaft to the right (direction
of rotation of the running engine).
To Next Page
Loading...
Need help?
General
