What to do if the auger stops rotating during mixing in my Jay-Lor Mixer?
If the auger of your Jay-Lor Mixer stops rotating during mixing, it may be jammed. Clear any packed material to resume mixing. Alternatively, the leading edge of the auger might be digging into the drum floor. In this case, adjust the auger height.
How to fix a 'dead spot' during mixing with my Jay-Lor Mixer?
If you notice a 'dead spot' during mixing with your Jay-Lor Mixer, where material won't mix in certain locations (commonly the front and back areas of the mixing chamber), ensure the machine is level when mixing. Also, check the condition of all knives and replace them as needed.
What to do if I see damage to the driveline of my Jay-Lor Mixer?
If you observe visible deformation, wear, or failure of the driveline in your Jay-Lor Mixer, it could be due to extreme loads or contaminants like sand. Replace the damaged components with Jaylor recommended parts.
To Next Page
General