EasyManua.ls Logo

Jayco Greyhawk 2018 - Utility Center

Jayco Greyhawk 2018
169 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
106




4. Open the “low point drains” by turning, then pulling the handles
up. They are installed at the lowest point of the water lines. A label
is placed on the outside of the RV to indicate where the drains are
located. The drains will need to be operated from inside the RV. Once
the label is found on the exterior sidewall, the drains will be found at
a corresponding location in the interior.
5. Drain the sink by removing the drain cap.
6. Turn ON the water pump and allow it to run as needed.
7. If the RV water heater has bypass valves: Set them to the BYPASS
conguration (refer to the Water Heater Bypass section).
8. Operate the toilet ush lever until water stops owing.
9. Relieve the water pressure using the P&T valve BEFORE removing
the water heater drain plug. If there is any water pressure present,
the water will spray out of the opening when the drain plug is
removed.
When you are nished draining the fresh water system, reverse these steps and dump the
grey and black water holding tanks. It is normal for some liquid to remain in the fresh water
tank after drainage procedure.
Utility Center
Water valve settings indicated on the utility center label:
 - Allows you to access water from all faucets using a pressurized water
source (referred to from here on as “city water”).
 - Allows you to ll your fresh water tank using city water.
 - Allows you to siphon ll your fresh water tank (using the 12-volt water
pump) when you do not have access to city water.
 - If the RV is not connected to city water, allows you to pump water from the
fresh water tank to all faucets using the 12-volt water pump.
Allows you to sanitize or winterize the water lines.
Allows you to sanitize the fresh water
tank.
Depending on your model, the city water connections may
be congured one of three ways:
1. . The City water
connection inlet will be located on the outside of
the motor home, and the pump switch inside on the
monitor panel.
2. . This utility center
contains the city water connection inlet, pump
switch, water valve controls, outside shower, black
tank ush inlet and a macerator discharge system.
3. . This utility center
contains an outside shower, city water connection
inlet, black tank ush inlet, pump switch and water
valve controls.




Table of Contents

Related product manuals