136
For good station reception, the antenna power supply must be turned ON to
view local television stations. Turning the antenna power supply ON sends
12-volt DC through the cable to the TV roof antenna. The voltage energizes
the transistors in the antenna head amplier. The TV signal then comes down
the cable to the outlets.
Turn the antenna power supply OFF to view cable television or to use a VCR
or DVD. The ON/OFF switch is located on the wall plate for the antenna
connection.
Please refer to the manufacturer’s instructions for setup, care and maintenance.
Exterior Entertainment Center (if so
equipped)
The exterior entertainment center is located on the curbside of the unit. You can access the
entertainment center by opening the exterior cargo door to the stationary open position.
Refer to the individual component manufacturer’s information for detailed operating
instructions.
To Next Page
Loading...
