48
Emergency Stopping
Always carry road ares or reective warning signs. Pull o the roadway as far as possible
for emergency stopping. Turn ON your vehicle hazard warning ashers. If traveling at
night, use three red warning indicators such as ares, reectors or lanterns as required by the
Uniform Vehicle Code and Model Trac Ordinance as follows:
6. Press the ON/OFF button to turn the system OFF.
7. All jacks be inspected to ensure they are retracted before moving the coach.
● Coach must be in PARK, with the engine running.
● Parking brake be engaged.
● Air bag suspensions automatically ll during any retract sequence or when
the parking brake is released. This can add a delay of 20 to 60 seconds to the
procedure.
1. Press the ON/OFF switch to turn the system ON.
2. Press and hold RETRACT button until it lights.
3. Press the FRONT button retracts both front jacks, pressing the REAR button retracts
both rear jacks. Pressing the RIGHT or the LEFT buttons will operate the right or left
jacks individually.
4. Press the ON/OFF button to turn the system OFF.
5. All jacks be inspected to ensure they are retracted before moving the coach.
If the touchpad is left ON and inactive for 4 minutes it shuts OFF automatically. To reset the
system, the coach ignition must be turned OFF, then back ON and the ON/OFF button on the
leveling system must be pressed again.
If the ignition is in the RUN position, jacks are down, the operator releases the parking
brake, all indicator lights ash, and the alarm beeper will activate. The system will then
automatically retract the jacks until the jacks are fully retracted or the operator resets the
parking brake.
If the ignition is in the RUN position, the parking brake is released, and the vehicle is
in motion, the system may activate the power unit to ensure that the retract pressure is
high enough to keep the jacks fully retracted. The LCD screen will display “JACKS UP
VERIFICATION” until the retract pressure has returned to normal. If the touchpad was
previously OFF, it will shut OFF again. No beeping will occur and the JACKS DOWN dash
light will not illuminate.
1. Set the parking brake.
2. Use UP or DOWN arrow buttons to scroll the display until it reads “MANUAL AIR
CONTROL” Press the ENTER button.
3. Press REAR button to dump air or press FRONT button to ll the air bags.
Troubleshooting information, error codes, and manual override of the power jacks can
be found in the Lippert Class C Hydraulic Leveling Owner’s Manual. Contact Lippert
Customer Service or your dealer for additional help.
To Next Page
Loading...
