Jayco Precept 2018 - Solar Prep (if so Equipped)

98

Solar Prep (if so equipped)
Your motor home may be equipped with a roof mount solar panel quick connection. This
allows a (customer purchased) solar panel to be installed permanently on the roof. Installation
will consist of the solar panel(s), regulator and wiring/fusing between the regulator and
batteries. There are no other solar plugs for portable solar panels on the vehicle.
The (black ABS) solar prep box is located in a basement compartment of the RV and
is marked with a solar prep label (indicating wire colors and polarity). There is also an
additional label indicating the RV is wired for solar.
When connected, the solar panel will supply power to the battery, the battery will supply
power to the converter, and the converter will supply power to all the 12V systems as needed.
seconds. Once the generator starts running, release the “START/STOP” switch. The
indicator above the switch will light up.
5. For better performance and engine life, especially in colder weather, let the generator
engine warm up for two minutes before turning “on” 120-volt appliances.
6. The small display (hour meter) is used to keep track of run time on the generator.
The will initiate an automatic generator start/stop sequence. This test attempts
to turn on the generator and allow it to run for at least 30 seconds before shutting it o, and
is used to conrm that the AGS is congured correctly for your generator type.
The  will disable the AGS system. The ENABLE and STATUS indicators
will go o and the generator (if running will shut o).
Disengaging the parking brake and turning on the ignition will disable the AGS system if
it was previously enabled. To reset it again, the parking brake must be set, and the ignition
turned o. The ENABLE switch on the command center panel must be selected again to put
the system in automatic start mode.
Replacing Light Bulbs
Before replacing a bulb, be sure the light is o. Do not touch the glass part of the new bulb
with your bare ngers. The skin oil left on the glass will evaporate when the bulb gets hot,
the vapor will condense on the reector and it will dim the surface.
Replacement light bulbs must be of the type, voltage and wattage listed on the lamp xture.
Use of incorrectly sized bulbs can overload lamp circuits and may create a re hazard by
overheating the xture.

