46
Locks on entrance and baggage doors need biannual lubri-
cation using a light coat of silicone spray. Conditions such as rain,
salt, dust and pollution may increase the maintenance needs.
Keyless Entry (if so equipped)
The keyless entry system is a battery powered system. The
following is an overview for programming and changing
batteries on the lock system. For detailed information, refer to the
manufacturer’s operator manual.
The battery powered entry system is a 4 button touch pad
programmable deadbolt lock. The 4 buttons are labeled “1|2”,
“3|4”, “5|6”, “7|8”. The button labeled “1|2” is the same button whether the number 1 or 2
is desired. Please note this handle uses touch technology. The buttons are activated by touch
and do not require pressing the buttons.
The entry system incorporates proximity sensing to determine when you want to activate the
lock. To operate the lock you rst must “wake up” the lock, by touching the wake up area to
the right of the buttons. This will illuminate the touch Pad buttons indicating that the touch
pad is ready for the code to be entered (refer to diagram below).
D
The “” button is the bottom button with the key diagram.
The enter button must be touched after the 4-digit code is entered. The factory code (3,7,1,5)
resets every time the batteries are removed for at least 10 seconds.
To Next Page
Loading...
