Operation
Entering and Leaving the Operator Station
30 9831/7750-1 30
Entering and Leaving the Operator Station
General
CAUTION Entering or leaving the operator station must only be made where steps and handrails are
provided. Always face the machine when entering and leaving. Make sure the steps, handrails and your
boot soles are clean and dry. Do not jump from the machine. Do not use the machine controls as handholds,
only use the handrails.
Operator can enter and leave the operator station from both side of the machine.
Make sure the machine is stopped and correctly parked before entering or leaving the cab. Refer to: Stopping
and Parking (Page 40).
When entering and leaving the cab always maintain a three point contact with the handrails and step. Do not
use the machine controls or steering wheel as handholds.
Entering the Canopy
1. Hold the two handrails, then use the steps to climb into the cab and swing yourself into the operators seat.