5 - 7
Cleaning/Changing the Suction Strainer
1. Prepare the Machine
Position the machine on level ground
Stop the engine. Remove the starter key.
2. Locate the suction Strainer
See Component Location Diagrams at the end of the
section.
3. Release Tank Pressure
See Releasing Tank Pressure.
4. Remove the suction Strainer
a. Remove the retaining bolts A and washers D, lift off
cover plate B.
b. Remove the suction strainer C and clean with a
suitable solvent or, if renewing discard.
5. Fit the Suction Strainer
Fitting is a reversal of removal.
6. Check the Hydraulic fluid Level
See Checking the Fluid Level.
7. Seal the System
Refit the cover plate B together with its 'O'-ring.
Note: Check the 'O'-ring, if it is worn or damaged replace it
with a new one and secure with bolts A and washers B.
Section 3
Routine Maintenance
9803/6400
Section 3
5 -7
Issue 1
Hydraulics (continued)
AD
B
C
To Next Page
Loading...
Need help?
General
