8 USER MANUAL
INSPECT BEFORE YOU CONNECT
By implementing a simple yet important process of
proactively inspecting and cleaning before mating,
you can prevent poor signal performance and
equipment damage.
THE SOLUTION
INSPECT BEFORE YOU CONNECT
DIRTY FIBER – Prior to Mating
Loose debris and dirt are much easier to clean prior to mating the 2 connector sides. By visually inspecting ber
connectors at every stage of handling before mating them, you are proactive in preventing signal loss and
equipment damage. Connectors are much easier to clean prior to mating, before embedding debris into the ber.
CLEANED FIBER – Before Embedding Debris
CLEANED FIBER WITH EMBEDDED DEBRIS
After Mating and Multiple Cleanings
If dirty connectors are not inspected and cleaned prior to mating, dirt and debris can embed into the ber surface
causing permanent damage. By visually inspecting after a problem is discovered, you are taking a reactive
approach. By this time, connectors and other equipment may have suered permanent damage.
DIRTY FIBER – Prior to Mating
Embedded debris cannot be removed or cleaned!
PROACTIVE INSPECTION
REACTIVE INSPECTION
To Next Page
Loading...
Need help?
General
