JDS Uniphase SmartClass E1 - Getting Started

Chapter 1 Getting Started
Starting an application
SmartClass E1 Tester Remote Control Reference Guide 3
Starting an application
After logging into the unit, the next step is launching an application.
To start an application
This command attempts to start the specified application.
Command rc app e1bert | e1pulseshape | e1jitter | e1mfcr2 |
datacombert | datacomfr
The option application should be available otherwise it won't be launched. For
example, if you attempt to launch e1pulseshape on a unit that doesn’t include
the pulse shape option, the attempt will fail.
Example rc app e1bert
Exiting an application
After running your tests, you should exit the application.
To exit an application
This command attempts to exit the running application.
Command rc exit