2
SmartClass E1 Tester Remote Control Reference Guide 5
Chapter 2
Setup commands
This chapter describes the commands to set or query the parameters of the E1
Tester. Topics discussed in this chapter include the following:
– “About the setup commands” on page 6
– “Setup subsystems” on page 7
– “Changing a setup” on page 7
– “Changing multiple setups” on page 8
– “Changing multiple setup array elements” on page 9
– “Querying a setup” on page 9
– “Querying a setup - g2” on page 10
– “Resetting multiple setups to their default value” on page 10
– “Resetting all setups to their default value” on page 10
– “Querying the attributes of a setup” on page 10
– “Querying the value and attributes of a setup” on page 11
– “Querying multiple setup values and attributes” on page 11
– “Querying the constraints of a setup” on page 12
– “Saving setups to a file” on page 13
– “Restoring setups from a file” on page 13
– “List saved setup files” on page 13
– “Deleting a saved setup file” on page 13
– “Listing all setups” on page 14
To Next Page
Loading...
