4
SmartClass E1 Tester Remote Control Reference Guide 19
Chapter 4
Result commands
This chapter describes the commands to perform or query a result on the E1
Tester. Topics discussed in this chapter include the following:
– “About the result commands” on page 20
– “Result subsystem” on page 20
– “Querying a result” on page 20
– “Querying the attributes of a result” on page 21
– “Querying the value and attributes of a result” on page 21
– “Querying multiple result values and attributes” on page 22
– “Listing all results” on page 22
To Next Page
Loading...
