JDS Uniphase SmartClass E1 - Querying a Setup - G2

Chapter 2 Setup commands
Querying a setup - g2
10 SmartClass E1 Tester Remote Control Reference Guide
Querying a setup - g2
This command queries for the value and attributes of one or more setups.
Command rc s_get_g2 setup_name setup_name
Response 2:SCE:cmsend:ack::s_get_g2 "<?xml
version='1.0'?><response>"<setup
id='TestApp.Module1.IntSetup' applicable='1' change-
able='1' restartRequired='1' type='int32'
format='default'><valueProperties><minValue>0</
minValue><maxValue>0</maxValue><granularity>0</granu-
larity></valueProperties><value>1</value></setup></
response>"
For array setup, a range must be specified when query such setup.
Command rc s_get setup_name "(@index1,index2)"
Resetting multiple setups to their default value
This command attempts to set the specified setups to their default value. If any
invalid setups are specified, the command proceeds. The response acknowl-
edgement will contain the invalid setup names.
Command rc s_mset_default setup_name setup_name …
Response 2:SCE:cmsend:ack::s_mset_default
Resetting all setups to their default value
This command attempts to set all the current setups to their default values.
Command rc s_set_all_default
Response 2:SCE:cmsend:ack::s_set_all_default
Querying the attributes of a setup
This command queries the attributes of the setup, namely its applicability, its
changeability, and restart required. A setup is applicable if or when the setup
has some meaning with respect to the current setup of the instrument. Typi-
cally setups that are not applicable are not displayed on a user interface.
Changeability means that it is valid for the user to change the setup. Typically