3
SmartClass E1 Tester Remote Control Reference Guide 15
Chapter 3
Action commands
This chapter describes the commands to perform or query an action on the E1
Tester. Topics discussed in this chapter include the following:
– “Action subsystem” on page 16
– “Executing an action” on page 16
– “Querying the state of an action” on page 16
– “Querying the attributes of an action” on page 17
– “Querying the state and attributes of an action” on page 17
– “Querying the states and attributes of multiple actions” on page 17
– “Querying the states and attributes of multiple actions - g2” on page 18
– “Listing all actions” on page 18
To Next Page
Loading...
