Chapter 4 Result commands
Querying multiple result values and attributes
22 SmartClass E1 Tester Remote Control Reference Guide
severity is a string that denotes whether or not the result's current value is
normal.
range is a string that denotes whether or not the result's current value is in
range.
timestamp is an integer.
Querying multiple result values and attributes
This command queries multiple results for the value and attributes for each
result. Applicability is the same as setup applicability. Readiness indicates
whether the result is available. Some results take time to gather or calculate.
This indicates whether the measurement has been made. Severity denotes
whether or not this result's value is abnormal. Range denotes whether or not
the result's value is in its allowable range. Timestamp is the time at which the
result was last modified. This “time” is the time tick count since the system was
started.
Command
rc pr_mget_all result1_name result2_name …
Response
2:SCE:cmsend:ack:pr_mget_all result1_name, applicability,
readiness, severity, range, timestamp, value,
result2_name, applicability, readiness, severity, range,
timestamp, value, ...
value is the current value of this result.
applicability is a Boolean value and will be 0 (false) or 1 (true).
readiness is a Boolean value and will be 0 or 1.
severity is a string that denotes whether or not the result's current value is
normal.
range is a string that denotes whether or not the result's current value is in
range.
timestamp is an integer.
Listing all results
This lists all of the results within the measurement application.
Command
rc r_list
Response
2:SCE:cmsend:ack:r_list result_name result_name …
result_name
To Next Page
Loading...
