187
WARNING
259) Before opening the hood, make
sure that the engine is off and that the
ignition is in the STOP mode. Follow the
indications on the plate underneath the
hood. We recommend that you remove
the key fob if other people remain in the
vehicle. Leave the vehicle after the key
fob has been removed and the ignition
is turned to the STOP mode. During
refueling, make sure that the engine is off
(ignition device in STOP mode).
IMPORTANT
59) Always contact a Jeep Dealership to
replace the conventional battery. Replace
the traditional battery with a new one of
the same type (EFB - Enhanced Flooded
Battery) and technical specifications.
60) If climate comfort is to be favoured,
the Stop/Start system can be deactivated,
for a continuous operation of the climate
control system.
SPEED LIMITER
(where provided)
DESCRIPTION
This device allows the speed of the car to
be limited to values which can be set by
the driver.
The maximum speed can be set both
with car stationary and in motion.
When the device is active, the car
speed depends on the pressure at the
accelerator pedal, until the set speed
limit is reached.
ACTIVATING THE DEVICE
To activate the system, press the
button on the steering wheel fig. 155.
155 5520681D
The activation of the device is indicated
by the
symbol on the display, along
with a dedicated message and the last
speed value stored.
SPEED LIMIT PROGRAMMING
To store a speed value higher than the
displayed one, briefly press the SET
+ button. Hold the button pressed to
increase in 5 km/h steps.
To store a speed value lower than the
displayed one, briefly press the SET -
button. Press and hold the button to
decrease the speed by 5 km/h.
Each time the active speed limiter
is activated, it is set to the last
programmed value since the previous
activation.
NOTE The "Cruise Control" (where
provided) and "Adaptive Cruise Control
(ACC)" functions (where provided) will
not be available while the Speed Limiter
function is in use.
NOTE The Speed Limiter can be set
while the vehicle is stationary or moving.
EXCEEDING THE PROGRAMMED
SPEED
By fully depressing the accelerator pedal,
the programmed speed can be exceeded
even with the device active (e.g. in the
event of overtaking).
If the set value of the active speed
limiter is exceeded manually with
acceleration, an acoustic signal is
emitted, the warning light flashes rapidly
and a message is displayed on the
instrument panel display.