Jeep Compass - Procedure for Charging from Adomestic Power Socket (Ac)

247
charging station and the charging port
located on the car.
PROCEDURE FOR
CHARGINGFROM A
DOMESTIC POWER
SOCKET (AC)
(Plug-in Hybrid version)
334) 335) 336) 337) 338) 339) 340) 341) 342) 343)
98) 99) 100) 101) 102) 103) 104) 105)
CHARGING PROCEDURE
WARNING Always connect the cable to the
charging port of the domestic mains first
and only then to the car.
The high-voltage battery of the system
is charged by connecting the "Mode 2"
charging cable, supplied with the car, to
an AC charging port.
For the characteristics of the "Mode 2"
cable, refer to the "Power sources that
can be used - Mode 2 cable" chapter.
To charge, proceed as follows:
park the car safely (automatic
transmission lever in position "P" - Park);
engage the electric parking brake;
switch off the engine;
take the charging kit located in the
boot;
remove any dust that may have
accumulated on the charging connector
and charging port;
unroll the charging cable and connect
it to an AC charging port, fig. 250;
250 J0B6000E
NOTE From the moment the plug is
connected to the domestic mains
charging port, the 3 LEDs on the control
unit of the cable will flash for approx.
6 seconds (control unit switching on
phase);
open the charging flap (1) fig. 251
located on the left side by pressing on
the area indicated by the arrow;
remove any dust that may have
accumulated on the charging connector
and charging port;
1
251 5520614D
remove the protective cover (2)
fig. 252 from the charging port and
attach it to the device (3);
grasp the charging connector by
the handle (4) fig. 253, remove the
protective cover (where provided) and
insert it into the charging port (5) until
you hear the click indicating that it has
been locked;