IN CASE OF EMERGENCY
294
CHANGINGA WHEEL
377) 378)
JACK
Please note that:
the jack requires no adjustment;
the jack cannot be repaired and in the
event of a fault it must be replaced by
another genuine one;
no tool other than its cranking device
may be fitted on the jack.
Maintenance
prevent any dirt from depositing on the
"worm screw";
keep the "worm screw" lubricated;
never modify the jack.
Conditions for non-use
temperatures below -40°C;
on sandy or muddy ground;
on uneven ground;
on steep roads;
in extreme weather conditions:
thunderstorms, typhoons, hurricanes,
blizzards, storms, etc...
in direct contact with the engine or for
repairs under the car;
on boats.
JACK/SPAREWHEEL STOWAGE
The spare wheel or, depending on the
version, space-saver spare wheel is
located under the boot floor.
If provided, the tools are kept in the tool
compartment around the spare wheel
stowage compartment (for diesel and
petrol versions), or in the box indicate
the spare wheel (Plug-in Hybrid version)
fig. 304.
For Plug-In Hybrid versions:
1. Open the liftgate and then remove the
load platform.
2. Remove the jack and spare wheel
fastener (1) fig. 304.
3. Remove the jack unit and the wrench
for removing the fixing bolts from the
spare wheel. Turn the screw of the jack
to loosen the wrench and separate it
from the jack assembly.
4. Take the spare wheel out of the boot.
304 5520749D
For petrol/diesel versions:
1. Open the liftgate.
2. Lift the access lid using the handle on
the load bed.
3. Remove the fastener securing the
spare wheel (fig. 305), and remove the
spare wheel from the car.
For petrol/diesel versions, the jack is
located in the toolbox inside the spare
wheel.
305 5520379D
To Next Page
Loading...
