253
CHARGINGCABLE
EMERGENCYUNLOCK
(Plug-in Hybrid version)
If the charging cable does not unlock at
the end of the charging procedure, you
can unlock it manually.
If, after closing and opening the doors by
pressing the relevant buttons
/
located on the key, it is still not possible
to remove the charge cable from the port
on the car, it is possible to act manually
by operating a special emergency
unlocking device located on the left
side of the boot and performing the
operations described below:
open the liftgate;
remove the parcel shelf from the load
platform (if provided);
use the tip of the ignition key to
remove the access flap (1) fig. 262,
located on the trim panel on the left
inside the boot, in order to release the
cable;
grip the release cable retainer and
gently pull it to manually release the
charging port actuator, fig. 263;
pull the charging connector out of the
charging port located on the car;
put the charging cable and cable
retainer back correctly.
NOTE Excessive force may break the
cable retainer.
NOTE To restore correct operation of the
system, contact the Jeep Dealership.
262 5520745D
263 J0B6492E
CHARGINGFUNCTIONS
(Plug-in Hybrid version)
CHARGING SCHEDULE
By acting on the Uconnect™ system
display and selecting the "Charging
Schedule" function you can set the start
and end time at which the high-voltage
battery is to be charged.
For more information see the
descriptions in "Multimedia" section.
If the car is charging, but it is
outside the charging range set via the
Uconnect™ system, the LED (A) (1)
fig. 264 (located near the charging port)
will light up and the LED (2) will turn on
with blue light.
If charging is in progress, the LEDs will
light on with green flashing/green steady
light depending on the state of charge of
the battery portion indicated by the LED.
264 5520747D