23
the key is physically removed from the
ignition device.
2. Perform one of the following methods
to lock the car:
Push the button on the interior door
central locking switch with the driver
and/or passenger side door open.
Push the button on the exterior
Passive Entry door handle with a key
available in the same exterior zone, refer
to the "Doors" chapter in this section for
further information.
Press the button on the key.
3. Close the doors if they are open.
NOTE Once the security system is
armed, it remains in that state until it
is disarmed by following either of the
procedures described in this chapter.
If a power loss occurs after arming the
system, you must disarm the system
after restoring power to prevent alarm
activation.
Disarm the security alarm
The car security alarm can be disarmed
using any of the following methods:
Press the button on the key.
Grasp the Passive Entry door handle
to unlock the door, refer to the "Doors"
chapter in this section for further
information.
Turn the ignition device of the system
to a different other than the STOP
position.
For cars equipped with Keyless
Enter-N-Go – Passive Entry, press the
START/STOP button of the ignition
device (requires at least one valid key in
the car).
For vehicles not equipped with Keyless
Enter-N-Go – Passive Entry, insert a valid
integrated vehicle key into the ignition
device and turn the key to the ENGINE
position.
NOTES:
The driver's door lock and the button
on the key fob cannot arm or disarm
the security alarm of the car.
The security alarm of the car remains
armed during access through the power
liftgate. Pushing the button
will not
disarm the security alarm of the car.
If someone enters the car through the
liftgate and opens any door the alarm
will sound.
When the security alarm of the car
is armed, the interior power door lock
switches will not unlock the doors.
The security alarm is designed to protect
the car; however, it is possible to create
conditions which may cause a false
alarm. If one of the previously described
insertion sequences was implemented,
the security alarm is activated regardless
of whether someone is inside the car or
not. If you stay inside the car and open
a door, the security alarm system is
activated by sounding the alarm. In this
case, switch of the security alarm of the
car.
If the security alarm of the car is on and
the conventional battery is disconnected,
the security alarm will remain active
when the conventional battery is
reconnected: the external lights will flash
and the horn will sound. In this case,
switch of the security alarm of the car.
Manually overriding the security
alarm
The system will not arm if you lock the
doors using the manual door lock button.
DOORS
Manual door locks
To lock each door, turn the lock knob (1)
fig. 14 on the trim panel for each door
forward until the lock indicator
cannot
be seen. To unlock the front doors, pull
the inside door handle to the first notch
or rotate the door lock button until the
lock indicator is hidden. To unlock the
rear doors, rotate the door lock button
until the lock indicator
is hidden.
To Next Page
Loading...
Need help?
General
