KNOWING YOUR CAR
16
the energy needed to charge the
high-voltage battery.
"ELECTRIC mode": this operating mode
activates the operation of the electric
motor only. If high performance is
required (pressing on the accelerator
pedal) the electric motor and the heat
engine will run simultaneously. A
continuous acoustic warning will sound
in this case to warn the driver.
WARNING
7) With "HYBRID" mode active, the car
stationary and the ignition device in the
ENGINE position, opening the bonnet
automatically activates the heat engine.
8) With "ELECTRIC" mode active, the car
stationary and the ignition device in the
ENGINE position, opening the bonnet
automatically activates the heat engine.
THE KEYS
2) 3)
KEY WITH REMOTE CONTROL
9)
The metal insert of the key operates:
the ignition device;
the door lock.
Press button (1) fig. 6 to open/close the
metal insert.
6 5520293D
ELECTRONIC KEY
(versions with "Keyless Enter-N-Go"
system)
10)
On versions equipped with "Keyless
Enter-N-Go" system, the car features an
electronic key fig. 7, of which two copies
are provided.
7 5520294D
All doors can be programmed to unlock
on the first press of the button. Refer
to the “Settings” paragraph in the
“Multimedia” section for further
information.
NOTE The key fob may not be found if it
is located next to a mobile phone, laptop
or other electronic device; these devices
may block the wireless signal of the key
fob.
The key can be used to lock or unlock
the doors and liftgate from distances up
to approximately 20 using a hand-held
key fob. The key fob does not need to be
pointed at the car to activate the system.
NOTE In case the ignition device
does not change with the push of a
button, the key fob may have a low or
fully depleted battery. A low key fob
battery can be verified by referring to
the instrument panel, which will display
directions to follow.
To Next Page
Loading...
Need help?
General
