17
Emergency key removal
8 5520295D
The emergency key (fig. 8) can be used
to access the conventional car if the
car battery or key battery is flat. The
emergency key is also used to close the
glove box and can be taken with you
when you hand the car over to the valet
parking.
To remove the emergency key (2) fig. 9
from the key of the keyless ignition
system, slide aside the mechanical
stop (1) on the top of the key with your
thumb, then remove the key with your
other hand.
9 5520296D
Unlocking the doors and the liftgate
Press and release the button (2) fig. 6
or (1) fig. 7 on the key once to unlock
the driver's door or twice within five
seconds to unlock all doors and the
liftgate.
With power liftgate: press the button on
the key
(4) fig. 6 or fig. 7 twice
within five seconds to open or close the
liftgate.
All doors can be programmed to unlock
on the first press of the
button.
Refer to the “Settings” paragraph in
the “Multimedia” section for further
information.
The direction indicators blink to indicate
that the unlock signal was recognised.
The illuminated entry system will be
activated.
Release button on the first push of the key
This function lets you program the
system to unlock either the driver's
door or all doors on the first push of
the
button on the key fob. For
more information on the current
setting,refer to "Settings" paragraph in
the "Multimedia" section.
Door and liftgate locking
Press and release the button (3) fig. 6
or (2) fig. 7 on the key to lock all the
doors and the liftgate.
If the function is set using the
Uconnect™ system, the direction
indicators will flash to confirm the door
lock. Refer to the “Settings” paragraph
in the “Multimedia” section for further
information.
REPLACING THE ELECTRONIC KEY BATTERY
To replace the battery, proceed as
follows:
remove the emergency key (as
described above);
separate the two half-shells of the key
using the tip of the emergency key, a
size 2 flat blade screwdriver or a coin
(fig. 10), then lever gently to separate
the two half-shells. During the separation
operation, act with caution to avoid
damaging the seal.
10 5520677D
To remove the CR2032 battery, turn
the back cover to open it (battery facing
down), tap it gently on a solid surface
such as a table or the like to take out the
battery, then replace it. When replacing
the battery, pair the + sign on the battery
with the + sign inside the battery
retainer, located on the back cover. Do
not touch the replacement battery with
your fingers as contact with skin grease
To Next Page
Loading...
Need help?
General
